|1ère page:||Raccord cannelé 12 & 13mm (1/2")|
|2ème page:||G1/4" filetage extérieur|
|Compatibilité:||Tubes rigides (PUR), tuyaux souples (PVC, Silicone, Neoprene)|
|Longueur de filetage:||5mm|
13mm barb fitting made from nickel coated brass with O-ring seal for PVC,PU,PA,silicone or PE hoses with an inner diameter of 11-13mm. G1/4" outer thread.
Note: For safety reasons we recommend fixation of the hose with a hose clamp or zip tie.
Overall length: 27mm
Hose inner diameter: 11 to 13mm
Inner diameter of connector: 9,9mm
Thread length: 8mm
Note for watercooling beginners:
The connectors for imperial hoses(7/16", 3/8", ½") are provided with measurements in mm in our shop. These can differ by +-1mm, which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp, a larger fitting should be chosen. With some fittings that tend to be larger, it is possible though that a hose with an inner diameter of 13mm actually does seal without a hose clamp.
10mm (3/8") hose clamp: up to 8mm none, from 10mm up required
10mm (7/16") hose clamp: up to 8mm none, from 10mm up required
12mm (1/2") hose clamp: up to 11mm none, from 12mm up required
13mm (1/2") hose clamp: up to 11mm none, from 13mm up required