- Article n°: 63268
- Fabricant no.:
- EAN: 4049469088248
- Poids: 0,03 kg
Date de livraison inconnue
incl. TVA plus frais d'envoi
|1ère page:||Raccord cannelé10mm (3/8")|
|2ème page:||G1/4" filetage extérieur|
|Compatibilité:||Tubes rigides (PUR), tuyaux souples (PVC, Silicone, Neoprene)|
|Longueur de filetage:||5mm|
|Pivotant:||Oui - 360°|
A well-known problem and here is the solution!
What is the best hose management to prevent kinking, how to avoid angled connectors to allow maximum flow? Now a well-known technology has been adopted to the watercooling sector by our designers to allow a solution which before was only possible with multiple different fittings.
The ball core of the fitting allows free adjustment of the barb, up to an angle of 30°. Even if using the full possibilities of this fitting the flow rate is barely compromised. The knurling on this fitting allows easy and quick tool-free installation.
This fitting gives many new possibilities unknown before!
Material: Silver nickel coated
Height (without thread): 38mm
Diameter bottom end: 20mm
Hose fitting length: 24mm
Fitting inner diameter: 8mm
Thread length: 5mm
Extent of delivery:
1x 10mm (3/8") barbed fitting G1/4 with O-ring gasket (high-flow) - ball rotation - silver nickel
Note for watercooling beginners:
The connectors for hoses(7/16", 3/8",1/2") are provided with measurements in mm in our shop. These can differ by +-1mm, which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp, a larger fitting should be chosen. With some fittings that tend to be larger, it is possible though that a hose with an inner diameter of 13mm actually does seal without a hose clamp.
10mm (3/8") hose clamp: up to 8mm none, from 10mm up required
10mm (7/16") hose clamp: up to 8mm none, from 10mm up required
12mm (1/2") hose clamp: up to 11mm none, from 12mm up required
13mm (1/2") hose clamp: up to 11mm none, from 13mm up required